Canon A40 trouble

[Tom Wilson]

On Tue, 2005-06-07 at 22:00, Robert Hemus wrote:
> Rick, I dmesg | fgrep and got this;
> 
> root at libranet:~# dmesg | fgrep usb
> usb.c: registered new driver usbdevfs
> usb.c: registered new driver hub
> usb.c: new USB bus registered, assigned bus number 1
> host/usb-uhci.c: $Revision: 1.275 $ time 20:17:46 Aug  3 2003
> host/usb-uhci.c: High bandwidth mode enabled
> host/usb-uhci.c: USB UHCI at I/O 0xcc00, IRQ 11
> host/usb-uhci.c: Detected 2 ports
> usb.c: new USB bus registered, assigned bus number 2
> host/usb-uhci.c: USB UHCI at I/O 0xd000, IRQ 5
> host/usb-uhci.c: Detected 2 ports
> usb.c: new USB bus registered, assigned bus number 3
> host/usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 10
> host/usb-uhci.c: Detected 2 ports
> usb.c: new USB bus registered, assigned bus number 4
> host/usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 11
> host/usb-uhci.c: Detected 2 ports
> usb.c: new USB bus registered, assigned bus number 5
> host/usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
> usb.c: registered new driver hid
> input0: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on
> usb2:2.0
> usb.c: USB device 2 (vend/prod 0x3f0/0x3304) is not claimed by any
> active driver.
> usb.c: registered new driver usblp
> printer.c: usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2
> vid 0x03F0 pid 0x3304
> usbdevfs: remount parameter error
> Is my problem in theis line?  usbdevfs: remount parameter error?
> Oh, by the way this is LN 2.8.1
> Bob

Bob,

Plug the camera in and then just run dmesg by itself.  The last few
lines of output give you the information about the camera.  Go ahead and
post the output if you wish.  

Tom Wilson 
McSwain Carpets 
513.771.1400 x4433 
----- 
Iron Law of Distribution: Them that has, gets.