IDE messages I'm not seeing in syslog

[Kurt Wall]

On Sat, Dec 17, 2005 at 10:59:29PM -0500, Matthew Carpenter took 89 lines to write:
> hda: dma_intr: status=0xd0 { Busy }
> 
> ide: failed opcode was: unknown
> hda: DMA disabled
> hda: set_drive_speed_status: status=0xd0 { Busy }
> ide: failed opcode was 100
> ide0: reset: success
> 
> 
> 
> I can see these through dmesg, but not in syslog.
> This is the default Kubuntu syslog config, so I would imagine I should be able 
> to see it in one of the logs... but not.

I don't know why these aren't showing up in your system logs. As for
dmesg, it is a ring buffer maintained by the kernel, so it doesn't
necessarily contain only the boot messages. I would think you could
edit /etc/syslog.conf to fix what I can only describe as an apparently
broken syslog setup.

Kurt
-- 
"Protozoa are small, and bacteria are small, but viruses are smaller
than the both put together."