Lousy Network Performance

[Kurt Wall]

On Tue, Jun 28, 2005 at 08:41:18AM -0500, Net Llama! took 0 lines to write:
> On Tue, 28 Jun 2005, Kurt Wall wrote:

[...]

> > $ ethtool -i eth0
> > driver: tulip
> > version: 0.9.15-pre12
> > firmware-version:
> > bus-info: 00:0d.0
> > $ ethtool -i eth1
> > driver: tulip
> > version: 0.9.15-pre12
> > firmware-version:
> > bus-info: 00:0e.0
> 
> What do you get from miitool eth0 and eth1?

$ mii-tool eth0 eth1
eth0: negotiated 100baseTx-FD, link ok
  product info: vendor 00:c0:b4, model 0 rev 8
  basic mode:   autonegotiation enabled
  basic status: autonegotiation complete, link ok
  capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
  advertising:  100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
  link partner: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
eth1: negotiated 100baseTx-FD, link ok
  product info: vendor 00:10:18, model 33 rev 2
  basic mode:   autonegotiation enabled
  basic status: autonegotiation complete, link ok
  capabilities: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
  advertising:  100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD
  link partner: 100baseTx-FD 100baseTx-HD 10baseT-FD 10baseT-HD

Here's what lspci says (the relevant info appearing near the bottom
of the listing):

$ lspci
[...]
00:0d.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20)
00:0e.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20)

For the record, I believe my routing table is correct:

$ route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.0.0     192.168.0.1     255.255.255.0   UG    0      0        0 eth1
69.17.59.0      0.0.0.0         255.255.255.0   U     0      0        0 eth0
127.0.0.0       0.0.0.0         255.0.0.0       U     0      0        0 lo
0.0.0.0         69.17.59.1      0.0.0.0         UG    1      0        0 eth0

Kurt
-- 
Personifiers Unite!  You have nothing to lose but Mr. Dignity!