pcmcia on Suse 8.0

[Net Llama!]

On 07/28/03 19:53, Rick Sivernell wrote:

> On Mon, 28 Jul 2003 21:59:40 -0400
> dep <dep at linuxandmain.com> wrote:
> 
> 
>>quoth Rick Sivernell:
>>| Suse users needed<g>
>>|
>>|    Got myself a copy of suse 8.0 pro. most evertything is working ok,
>>| but not ifconfig. This was a full fresh install over Caldera 3.1.1.
>>| Now cardctl status ident and config is proper as it should be. pcmcia
>>| start says it is ok but when I do ifconfig all I get is lo setup and
>>| running. it seems to be about one step away from complete. I set
>>| everythoing per Yast2, but that failed to set
>>| /etc/pcmcia/network.opts at all. I fixed that, Not sure what to do
>>| next here.
>>|
> DEP
> 
>    Suse Installed lilo, I did find a acpi=y set it to off and rebooted. no joy.
> I have found that the system is using axnet_ca it should be pcnet_cs. Can not
> find where to change it at. Found it on the last line of dmesg. boot fine and
> acts as if pcmcia is ready, dongle has all lights bright, cardctl says it is good
> and it finds the proper card Linksys pcmpc 100. just no ifconfig for pcmcia.


I think the pcmcia modules are defined somewhere like 
/etc/pcmcia/pcmcia.opts.  grep through /etc/pcmcia, assuming that SuSE puts 
their pcmcia stuff in there.


-- 
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
L. Friedman                       	       netllama at linux-sxs.org
Linux Step-by-step & TyGeMo: 		    http://netllama.ipfox.com

   9:00pm  up 13 days, 23:43,  1 user,  load average: 0.65, 0.41, 0.39