Compilation problems

[Joel Hammer]

Did you make modules and make modules_install?
Check in /lib/modules to see if things went ok.
You can load modules by hand if modprobe isn't working. No big deal.
Joel


On Mon, Jul 21, 2003 at 03:34:58AM +0200, ionmich at mail.gr wrote:
> I run Caldera e2.4. The kernel does not provide USB support for
> my scanner. I downloaded kernel 2.2.18 which does support USB,
> compiled it, installed it, then rebooted. Everything appeared to
> run normally but I could not connect to the scanner. I checked
> the boot-up errors and found,"......./usb-uhci.o:couldn't find
> the kernel version the module was compiled for." Just to make
> sure I deleted the entire linux2.2.18 source directory, untarred
> the source files again, re-configured, re-compiled, and
> re-installed. I checked that the file date on usb-uhci.o had
> changed and re-booted. I got the same error message. 
> 
> Can someone explain why, and how to get around the problem?
> 
> -------------------------------------------------------------
> http://www.mail.gr/ - Get Your Private Free Email Address!
> http://www.ringtone.gr/ - Ringtones & Logos for your mobile!
> _______________________________________________
> Linux-users mailing list
> Linux-users at linux-sxs.org
> Unsubscribe/Suspend/Etc -> http://www.linux-sxs.org/mailman/listinfo/linux-users