PCMCIA config for eth0

[Richard R. Sivernell]

List

    I have been trying to get a xircom combo ether card to
load and go to the net. I have read & reread many times the howto.
This laptop had peanut linux running beatiful with this card. Now I
have eWorkstation 3.1.1 on the hard drive and cannot set up cad.

1. Dmesg says resources are busy
2. cardctl ident knows the proper card
3.  modprobe of xirc2ps_cs & serial_cs
4.  lsmod shows all loaded with no use.
5.  ifconfig fails to create eth0

Does  any one have a isapnp.conf that has the pcmcia ether setup.
or tell me how to fix my problem. You also can contact me offline.

Thanks in advance.

cheers

-- 
Rick Sivernell
Dallas, Texas  75287
972 306-2296
res005ru at gte.net
Caldera Open Linux eWorkStation 3.1.1
Registered Linux User

   .~.
  / v \
 /( _ )\
   ^ ^
In Linux we trust!