small problem

[Keith Antoine]

I am just about closing off and bedding down, but!
I managed to backup all essential stuff today and reinstall eServer 3.1.1, 
which has given me back my ability to print. Reinstalled quit a bit but I now 
have a small problem, 2 in fact, that I might ask about.

Have no parallel printer port it seems, I do have usb. Thjought it might be 
that the ||printer is not enabled in the kernel. Went to root called xconfig 
and it said that command gcc was not available ?? Maybe not installed but i 
did do a complete install, all goodies. I also cannot undo tar files as 'tar' 
is not in my path ?? now why would that be !!

Am going to look on the install cd to see if i can find them.

Any comments would bve appreciated. Gain one lose 2

-- 
Keith Antoine aka 'skippy'
18 Arkana St, The Gap, Queensland 4061 Australia PH:61733002161
Retired Geriatric, Sometime Electronics Engineer, Knowall, Brain in storage